Thingiverse
Valken VSL Speed Feed
door Rklenke
1
Downloads
1
Likes
0
Makes
VSL SF lid requires you to print the first 3 layers (at .2mm or a total of .6mm) in TPU and switch over to PETG. I suppose you could technically print the whole thing in TPU, I just haven't tried it. If you do, let me know. Print with supports everywhere to get some supports in the latch area and hinge area, very small supports, easy to remove.
VSL rain lid is as described. Has the motivational phase "PUSH" on the inside to give you that needed boost as you reload your hopper. Print in PETG with supports everywhere. I have not tested shooting these with paint. They are fairly thin, so I'm not sure how many hits they'll take. The good thing is you can just reprint it if needed. Also don't get shot :)
VSL rain lid no motivation is plain. Print this if you are a camper. Still use supports.
The fingers will replace your worn out and saggy VSL fingers. Print 8 of them WITH SUPPORTS, remove supports after printing and install in your hopper lid. Print in TPU. This is a stiffer speed
VSL rain lid is as described. Has the motivational phase "PUSH" on the inside to give you that needed boost as you reload your hopper. Print in PETG with supports everywhere. I have not tested shooting these with paint. They are fairly thin, so I'm not sure how many hits they'll take. The good thing is you can just reprint it if needed. Also don't get shot :)
VSL rain lid no motivation is plain. Print this if you are a camper. Still use supports.
The fingers will replace your worn out and saggy VSL fingers. Print 8 of them WITH SUPPORTS, remove supports after printing and install in your hopper lid. Print in TPU. This is a stiffer speed
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
