Thingiverse
Vallejo Paint Holder
6.2k
Downloads
4.1k
Likes
29
Makes
Cleaned up the model by used jonpvogel to be printed as one piece and improved to reduce filament usage without compromising rigidity.
This can be printed with no support at all on my Anet E10 but there are some angles and bridges that may be hard for some.
This holder can be both hanged or stand by itself.
Thanks jonpvogel for the original model!
This can be printed with no support at all on my Anet E10 but there are some angles and bridges that may be hard for some.
This holder can be both hanged or stand by itself.
Thanks jonpvogel for the original model!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!