Thingiverse
Valve Cap
by VovaArd1313
0
Downloads
2
Likes
0
Makes
Simple but useful valve cap. The best print settings:
- 0.15mm layer height,
- disabled supports,
- wall loops and infill % don't matter.
This is a remix of the model on Printables:
https://www.printables.com/model/122027-tire-valve-cap-schrader
Difference of the remix compared to the original:
Now it prints without supports and it's easier to screw on.
- 0.15mm layer height,
- disabled supports,
- wall loops and infill % don't matter.
This is a remix of the model on Printables:
https://www.printables.com/model/122027-tire-valve-cap-schrader
Difference of the remix compared to the original:
Now it prints without supports and it's easier to screw on.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
