Slicer Discord
Valveless Pulse Jet – 3D printable model from Thingiverse Thingiverse

Valveless Pulse Jet

0 Downloads
1 Likes
0 Makes
Go to Model
### Optimized Lockwood-Hiller Style Valveless Pulse Jet.
##### Print V9 for best results.



---

**Update:** V9 runs well on gasoline with canned air. See the video below for reference. Will slightly pulse without air assist when running on isopropyl alcohol. A small amount of air assist results in decent reciprocation.

I would highly recommend PPE, goggles, gloves, and a respirator if possible. If you use compressed air from an air compressor, it is probably better for you. The terrible smell is very bad to breathe in. Use in a well-ventilated area. Do not run it if you value your arm hair.

---

**Video of it running: **

https://youtube.com/shorts/uwhEAB0an6s

---

**Tips to get it to run:**
- Spray fuel into the combustion chamber and swirl it around so it fumes. This makes initial ignition easier. Be prepared for a large backfire.
- Blow air into the intake (the smaller hole). Sometimes you may need to blow it out into the exhaust; if there's too much smoke inside, it'll snuff
Source
Thingiverse
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Wood PLA
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection