Thingiverse
Vampire Hunter Sleeved Insert
by tedcook94
4
Downloads
2
Likes
0
Makes
This is an insert for the Hasbro board game Vampire Hunter.
It's main goal is to prevent the large and heavy tower from rolling around in the box and damaging other components.
The four card slots hold each sleeved card type, and the tile slots have angled recesses that pop the tiles up when pushing on them.
The print is split into the four quadrants (labeled by their cardinal direction when in the box). The prints are as hollowed out as possible on the underside to save filament, and supports have been built in where necessary. You may need to use brims on some parts due to the low amount of build plate contact relative to the overall footprint of the pieces.
It's main goal is to prevent the large and heavy tower from rolling around in the box and damaging other components.
The four card slots hold each sleeved card type, and the tile slots have angled recesses that pop the tiles up when pushing on them.
The print is split into the four quadrants (labeled by their cardinal direction when in the box). The prints are as hollowed out as possible on the underside to save filament, and supports have been built in where necessary. You may need to use brims on some parts due to the low amount of build plate contact relative to the overall footprint of the pieces.
tedcook94 also publishes on
8 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
