Thingiverse
Van Halen "Jump" Night light
by NotTooLevel
9
Downloads
8
Likes
0
Makes
This is a simple nightlight of the one and only EVH doing what he does best - ROCK!.
Drift off to sleep knowing the legend is watching over you, I can't seem to locate the original photo credits since this photo is everywhere in different forms but will post if available.
Created using tool.itslitho.com and it should fit the most common nightlight fixtures with a 17mm width. Works with both LED and incandescent bulbs.
The opening is 17mm x 25mm x 1.6mm and the back corners can be easily trimmed if they extend past the base.
Printer: Creality Ender 3 v2
Filament: PLA
Brand: eSun
Color: White
Build plate adhesion: Optional but I used a raft without issues. Probably overkill
Print Settings: Using recommended lithophane settings and profile for Ender 3 from https://www.gadunky.com/litho-print-settings/.
Drift off to sleep knowing the legend is watching over you, I can't seem to locate the original photo credits since this photo is everywhere in different forms but will post if available.
Created using tool.itslitho.com and it should fit the most common nightlight fixtures with a 17mm width. Works with both LED and incandescent bulbs.
The opening is 17mm x 25mm x 1.6mm and the back corners can be easily trimmed if they extend past the base.
Printer: Creality Ender 3 v2
Filament: PLA
Brand: eSun
Color: White
Build plate adhesion: Optional but I used a raft without issues. Probably overkill
Print Settings: Using recommended lithophane settings and profile for Ender 3 from https://www.gadunky.com/litho-print-settings/.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!