Thingiverse
Vape Pen Kickstand
door rorosaurus
18
Downloads
14
Likes
0
Makes
A simple 3 or 5 leg kickstand for 11mm diameter vape pens. 5 legs recommended for the most stability with random table bumps. :D
Uses small paperclip (0.9mm diameter) pieces for the joints with small dabs of super glue on each side of each leg joint.
I personally printed in PLA but TPU is probably ideal. I recommend attaching the legs before sliding on to your vape.
It's a very tight fit, I slid it onto the vape with lots of downward pressure. To remove, I soaked in WD-40 for ~15 minutes then twisted while sliding off.
Uses small paperclip (0.9mm diameter) pieces for the joints with small dabs of super glue on each side of each leg joint.
I personally printed in PLA but TPU is probably ideal. I recommend attaching the legs before sliding on to your vape.
It's a very tight fit, I slid it onto the vape with lots of downward pressure. To remove, I soaked in WD-40 for ~15 minutes then twisted while sliding off.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
