Thingiverse
Vape stand
von tehfryst
5
Downloads
6
Likes
0
Makes
this is a vape stand I made for my Vessel Compass. I wanted it high and back on an angle. i have not printed this yet.
***Updated March 15, 2012***
I printed it and realised my inside gap was off. ive adjusted it.
***Updated March 15, 2012***
I printed it and realised my inside gap was off. ive adjusted it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!