Thingiverse
Vape Tools & Atomizer Station
door tinkertatertot
6
Downloads
5
Likes
0
Makes
A smaller vape station that can hold atomizers up to 30mm, tools, coil jigs, and more!
Depending on the resolution of your printer, and if you're using an SLA printer, and the resin you use, you may need to drill out the holes for the coil jig holes since they might end up smaller due to shrinkage. I did add some space for tolerance issues, but did have a couple holes that were just a bit too small.
As you can see, I even need to drill out the 4mm gaps for the ends of the coil jigs in some of the holes for whatever reason.
No need to print with supports. I would recommend hollowing out the model as well to save on resin. I printed it with 3 mm walls and it's quite sturdy. Still hungry for resin though!
Depending on the resolution of your printer, and if you're using an SLA printer, and the resin you use, you may need to drill out the holes for the coil jig holes since they might end up smaller due to shrinkage. I did add some space for tolerance issues, but did have a couple holes that were just a bit too small.
As you can see, I even need to drill out the 4mm gaps for the ends of the coil jigs in some of the holes for whatever reason.
No need to print with supports. I would recommend hollowing out the model as well to save on resin. I printed it with 3 mm walls and it's quite sturdy. Still hungry for resin though!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
