Thingiverse
Vape Top Box 75w
door hanzieo
126
Downloads
146
Likes
0
Makes
This model is a Vape that I built. It has a 75w Topbox Mini Driver and 2 x 18650 lipo cells in parallel for a 4.2v system. I have also added a juice pump.
It holds a whole day's worth of power and 2 days worth of juice. I decided to solder the battery's in and use the builtin USB to charge overnight(8 hours). Keep the cells removable for a fast external charge.
The lid has to be glued on after the circuit board is installed and wiring has been connected. Then glue the face on after you make sure the buttons move freely. I have printed and assembled this model 4 times with changes and improvements every time. V3 servived a week but was printed quite light. I printed this version V4(final) with 4 external shells 5 top layers and 5 bottom layers with 50% infill in PETG. Printed at 0.1 resolution. It is dense and strong.
This project was a design lesson and I was learning about adding doors, buttons, sliding battery doors and sliding circuit board mounting. All in all the tole
It holds a whole day's worth of power and 2 days worth of juice. I decided to solder the battery's in and use the builtin USB to charge overnight(8 hours). Keep the cells removable for a fast external charge.
The lid has to be glued on after the circuit board is installed and wiring has been connected. Then glue the face on after you make sure the buttons move freely. I have printed and assembled this model 4 times with changes and improvements every time. V3 servived a week but was printed quite light. I printed this version V4(final) with 4 external shells 5 top layers and 5 bottom layers with 50% infill in PETG. Printed at 0.1 resolution. It is dense and strong.
This project was a design lesson and I was learning about adding doors, buttons, sliding battery doors and sliding circuit board mounting. All in all the tole
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!