Vaporizer - Homemade

### Vaporizer (for weed vaping)

These 3D print parts are based on my original wood version (shown in a photo).

Data points:
Optimal Temperature Range of heatblock for Vaping is 355 to 375 (F).
Depending on your soldering iron, time to Temp’s will vary ~ 8 min’s.
After several min’s of vaping, the Temp will rise to above 375F, UnPlug it (or use a controller such as your favorite Arduino design).
[FYI - I’m done vaping before it gets too hot so I don’t use a controller]

When assembled, all plastic is far enough away from the heatblock and won’t cause softening/melting (PLA or ABS or bottle).

#### The Parts:
Plastic Bottle - Boss ring is sized for a 4 inch Western Family water bottle but you can use most any bottle that meets the geometry (and / or scale the Boss’s X and Y dim’s as needed). 4 inch dia bottle keeps sides away from heatblock. Make cutout as shown in photo.

Bottle Cap - No 3d printers when I made the original so I used plastic from Ace Hardware (parts sh