Thingiverse
Variable Delrin Wheel Spool Holder
von KauaiMaker
4
Downloads
3
Likes
0
Makes
This spool holder uses four delrin v-wheels and is compatible with various sized filament spools. Minimal footprint, ease of production, transportability, and modularity were the major influences behind this design.
Motivation: I needed a larger 1kg spool holder and had plenty of delrin wheels laying around so I made good use of them :P
Two pairs are required - one for each side of the spool.
Additional materials required:
4x Delrin V-Wheels with bearings (mine were from a Tevo Tarantula)
4x M5*25 Screws
4x M5 Nuts
Motivation: I needed a larger 1kg spool holder and had plenty of delrin wheels laying around so I made good use of them :P
Two pairs are required - one for each side of the spool.
Additional materials required:
4x Delrin V-Wheels with bearings (mine were from a Tevo Tarantula)
4x M5*25 Screws
4x M5 Nuts
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
