variable Ledbar for 10mm strips

This design provides a housing for a 10 mm wide led strip. The length is variable by printing the diffuser in 10 cm sections and the frame in 15 cm sections. The angle of the strip is determined by the brackets. So if desired, this strip can also be installed lying flat.

The frame parts are glued together using the rectangular connectors or alternatively fused together with a soldering iron. An end cap can then be attached in the same way. After the led strip has been glued in place, the diffuser can be pushed in segment by segment. Now the second end piece can be installed.
To connect the cables, I drilled a hole in one end beforehand.

My application is the illumination of my Ikea lacquer print cabinet with two 30 cm segments.