Thingiverse
Variable strength Clip / Clamp / Clothes Pin
door jostro
23
Downloads
19
Likes
0
Makes
Strong mini clamp or clothespin with gripping teeth. Grip pressure depends on the number of rubber band wraps. With 2 bands, I measured grip pressure to be about 2kg. The version shown holds easily a 4.5kg dumbbell.
The clothespin is 8cm long. There is a 150 micron (.15mm) tolerance around the swivel joint for a perfect fit.
Great to use outdoor in a corrosive environment such as near the sea. Will thus not rust stain clothes.
Can also be used when hiking, on boards, etc.
It's fully symmetric so you can duplicate it in the slicer and print both pieces at once.
I don't believe it scales to smaller size due to tolerance factors. It may scale slightly bigger, but I have not tried.
Any improvements suggestions are welcome. Please post makes and likes if you print it and like it. Thank you.
The clothespin is 8cm long. There is a 150 micron (.15mm) tolerance around the swivel joint for a perfect fit.
Great to use outdoor in a corrosive environment such as near the sea. Will thus not rust stain clothes.
Can also be used when hiking, on boards, etc.
It's fully symmetric so you can duplicate it in the slicer and print both pieces at once.
I don't believe it scales to smaller size due to tolerance factors. It may scale slightly bigger, but I have not tried.
Any improvements suggestions are welcome. Please post makes and likes if you print it and like it. Thank you.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
