Vase #528

This vase can be printed in spiral vase mode or spiralize outer contour in cura, but is not required to print this way. You can uncheck spiralize outer contour, set top layers to 0, set infill to 0%. Bottom layers set to 3 or more. Set walls to 2 or more for a more sturdy vase if not in vase mode. Can be scaled to fit your needs. The vase in the photo shows vase not scaled at 100% at 61mm wide and 108mm tall. It has not been tested for being watertight and probably isn't printed in vase mode. If you make it, please post a photo, I'd like to see your print!
Enjoy...

(Notes...... again....below....simple...but basic.... :)