Vase #777

This flower vase, for decorative purposes, can be printed in vase mode or spiralize outer contour in cura. Or, print in normal mode, uncheck spiralize outer contour, set top layers to 0. Set infill to 0%. Bottom layers set to 3 or more. Set walls to1 or 2, or more, for a more sturdy vase. Can be scaled to fit your needs. The vase in the photo shows vase not scaled at 100% at 94mm wide and 170mm tall. It has not been tested for being watertight. It is for decorative purposes. If you make it, please post a photo, I'd like to see your print!
Enjoy...

Tips are appreciated!

(Notes are below....;)