Vase mode challenge

I really like the desgin of the MCM Vase but I wanted to be able to print it in vase mode, and fast… Thus started my journey in this design. I really like where it came out, with a few caveats below. Good enough for me though, and with only a 2 hour print time! The angled top/spout makes a regular vase mode print impossible, so it's printed upside down… Make sure to use a bed with good adhesion. I used the Gold BambuLab Textured PEI Plate. This is also printed with an extremely wide line width (.8mm on a .4mm nozzle). It works great, and with the Polymaker PolyTerra filament I'm using it barely shows any layer lines. That being said, the layer lines are actually a nice design feature of this print because it is printed at such a strange angle. It actually enhances the look of the final product. I've uploaded two versions. One is smooth and round, and the other has a facetted neck that matches the number of fins on the sides of the vase. In the photo of the two vases, the sm