Thingiverse
Vase Mode Modular Drawers
di mSenyor
426
Download
244
Likes
0
Makes
These are modular drawers inspired by Dan O'Connell's Modular Drawers 2.0.
They print in vase mode (a drawer prints about 80 minutes, and the shell about 120).
The shells can be interlocked on any side either flush or offset (3/4, 1/2, or 1/4 way apart).
***EDIT***
Some people had issues with the shell printing into two separate parts. This seems to happen when the width of the extruded material is smaller than half the thickness of the model wall. Possible solutions are higher flow rates or scaling down the entire model 5% or so. The general idea is to make the inner and outer lines just barely overlap.
They print in vase mode (a drawer prints about 80 minutes, and the shell about 120).
The shells can be interlocked on any side either flush or offset (3/4, 1/2, or 1/4 way apart).
***EDIT***
Some people had issues with the shell printing into two separate parts. This seems to happen when the width of the extruded material is smaller than half the thickness of the model wall. Possible solutions are higher flow rates or scaling down the entire model 5% or so. The general idea is to make the inner and outer lines just barely overlap.
mSenyor pubblica anche su
1 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
