Thingiverse
Vase
von Schnuckdiwupp
17
Downloads
12
Likes
0
Makes
This vase has a thickness of 1.2 mm.
It has no angles above 45 ° and can therefore be printed on a standard FDM printer.
In my case, it was printed on a Ender 3 V2 with PLA and following settings:
- Temperature: 210 °C extruder, 60 °C base
- Wall line count: 4 (no infill)
In order to achieve a permanent waterproof design, it has to be post-processed.
I applied a layer of epoxy resin and it worked fine.
Have fun!
It has no angles above 45 ° and can therefore be printed on a standard FDM printer.
In my case, it was printed on a Ender 3 V2 with PLA and following settings:
- Temperature: 210 °C extruder, 60 °C base
- Wall line count: 4 (no infill)
In order to achieve a permanent waterproof design, it has to be post-processed.
I applied a layer of epoxy resin and it worked fine.
Have fun!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!