Thingiverse
VaseMode KeyboardStand
von mostly_harmless
14
Downloads
15
Likes
0
Makes
A strong sturdy vase mode keyboard stand printed with .8mm line width (with a .4mm nozzle).
The .STL file is 40mm tall (width) but you can scale the Z size to set the width to whatever you want.
Make 2 pieces, one for each end. It fits my Logitech G105 keyboard. It also fits several generic keyboards i tried it on.
PLA
vase mode (spiralize)
.3mm layers
.8mm line width (with a .4mm nozzle)
NO top
NO bottom
NO support
need a BRIM
If you print it in vase mode with .4mm line width it may be too flimsy.
.6mm line width might work. I only tried .8mm.
if you print normally (not vasemode) it might work, it might not. all the sharp corners are nicely rounded off (.4mm radius) using my settings. using a smaller line width may cause sharper corners which may stick to other places it wasn't meant to. or it may be fine....
made with Tinkercad "bent pipe" shape
The .STL file is 40mm tall (width) but you can scale the Z size to set the width to whatever you want.
Make 2 pieces, one for each end. It fits my Logitech G105 keyboard. It also fits several generic keyboards i tried it on.
PLA
vase mode (spiralize)
.3mm layers
.8mm line width (with a .4mm nozzle)
NO top
NO bottom
NO support
need a BRIM
If you print it in vase mode with .4mm line width it may be too flimsy.
.6mm line width might work. I only tried .8mm.
if you print normally (not vasemode) it might work, it might not. all the sharp corners are nicely rounded off (.4mm radius) using my settings. using a smaller line width may cause sharper corners which may stick to other places it wasn't meant to. or it may be fine....
made with Tinkercad "bent pipe" shape
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!