Vawt - Project

## This is a work in progress and is at the prototype stage and has been made as a proof of concept

***

Idea:
This is project is to basically do something with my 3D printer other than make daft little things.

The blades them self take a low amount of wind to start up in this configuration (gearing) and have been angled to create a small amount of lift whilst they are rotating.

In a small gust I have had 24v 3Amps (no load) at this stage of the project, I am next looking at gearing and upgrading the supports.

It is designed to fit 8mm stud and can be screwed into the plastic but I am going to use 10mm stud for more stability so I can stack more blades.

*Another note is that in the video for version 1 they are not glued together, they are a very very tight fit and some sanding was needed but will be glued with epoxy resin later in the project*.

Version 1 Short Video [Short Video](https://youtu.be/rPL6FWgwmCc)