Thingiverse
VDS Lamp support
by carlostmp
0
Downloads
0
Likes
0
Makes
This is a wall support for a yellow VDS Lamp that is usually used in sliding door motors. The original piece only comes with a flat base and 4 holes for screws. With this support you can put the light in a vertical wall.
It can be used upwards or downwards. The holes for the wall screws are oval, so you can move the support to put it level. The middle hole in the base is for the wire.
It's really simple to print. No need for supports, rafts etc. I recommend using PETG as this piece is supposed to be installed outdoors.
It can be used upwards or downwards. The holes for the wall screws are oval, so you can move the support to put it level. The middle hole in the base is for the wire.
It's really simple to print. No need for supports, rafts etc. I recommend using PETG as this piece is supposed to be installed outdoors.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!