Vector 3 SD Card Extension Clip

The Vector 3 3D Printer has the facility to add an SD Card but the socket for it is internal and therefore impractical. By adding an extension cable it is possible to take the SD card outside the case. This could be done by cutting the case but a simpler solution is to route the extension through the existing slot that carries the wiring to the Y-axis. Using this clip it is then possible to secure the extension to keep everything tidy.

Parts (available on ebay/Amazon)
1 x 48CM TF to Micro SD TF Flex Zip Extension Cable Memory Card Extender Cord Linker by LANMU
2 x M2.6 x 7mm self-tapping screws

Instructions
1. Raise the print bed to give clearance and remove the 'Front Top Cover'.
2. Insert the plug end of the extension into the edge connector on the main circuit board.
3. Thread the extension up inside the 'Main Frame Rear Cover' (isssue 44, page 19) and out the slot.
4. Attach the Clip to the 'Main Frame Rear Cover' using 2 x M2.6 x 7mm self-tapping screws. You will