Vector mounting base for Mini Drak

This design was directly influenced by
https://www.thingiverse.com/thing:2387704

However this is designed from scratch and is a lower version which easily clears the fuselage lid, and is a snug fit so the vector cannot fall out.

A second version has been added, which takes account of the fact that 3mm of velcro will increase the height by 3mm!. Not only has 3mm been taken off the bottom, the base that the Vector sits on has been modified so that the spar can move a further 1.5mm. This is about as low as you can get the Vector on the aircraft,

Note: although this is intended to be a tight fit to hold the vector in place, and although mine has never budged, it is recommended that a small piece of tape should be applied from the Vector to the holder as a secondary measure.