Vectrex Joystick Bracket

This is the bracket that hold the joystick module to the controller shell in a vectrex controller. It (like the arcs before it) was designed and made for a fellow vectrex owner whose controller had bit the dust when the mounting ears on the joystick bracket snapped and the joystick basically fell into the controller shell.

It's not a moving part so it's not much to say about it other than it probably should be printed with both raft and supports enabled to get somewhat perpendicular angles and planar mounting surface for the joystick module in the end. It was modelled after an original unbroken joystick bracket. The hole pattern for the mounting holes are off, I know. But the original also was spaced that way. I think it's a fail safe for irregularities in the controller shells. If the screw posts it is supposed to mount on are not straight, this slightly off center hole pattern may compensate for that. Anyway, the off center hole pattern IS intentional from my side. It fitted my co