Models
Zum Modell
Venom Head, Multi-part Remix
348
Downloads
344
Likes
6
Makes
This is a remix of the awesome 'Venom Head' model by Masterclip, I cut the model up in Meshmixer so that I could print the tongue in a different colour, I also cut the head in two and added a pin to save on the amount of supports needed while printing.
I would recommend scaling the pin down slightly until it is a tight fit, then just a small amount of superglue holds the rest together.
I would recommend scaling the pin down slightly until it is a tight fit, then just a small amount of superglue holds the rest together.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!