MakerWorld
Other House Models
Zum Modell
Vent Cover Flap
242
Downloads
129
Likes
162
Makes
I broke a flap off of the vent cover of my dryer vent when cleaning out the lint so I designed a replacement. I downloaded a different one off of Makerworld but it didn't fit, it was just a bit too short and a little too narrow. This is as close to an exact replica of the original as I could manage. The body is 109.5 mm wide, not including the little nubs that act as the hingeAnd 38.6 mm tall
Drew veröffentlicht auch auf
53 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!