Vent for Ultimaker 2

This thing can be attached to the top of your Ultimaker 2 by replacing two screws in the back of the printer. Attach a hose (6cm diameter, but can be customized) to reduce the smell when printing nasty materials.

Recommended Cura settings for printing this with PLA:
- Layer height: 0.1mm
- Shell thickness: 2mm
- Support Type: Touching buildplate
- Support structure: Grid
- Structure fill amount: 12%
- Structure Distance (x/y): 3mm (!This is important! You will have a hard time removing the support otherwise, and it will add a lot of useless material)
- Support distance (z): 0.1mm