MakerOnline
3D Printer
Model downloaden
Ventilation unit [Requires drone motor]
30
Downloads
13
Likes
0
Makes
Ventilation unit for drone motor. Made for multistar 2213-935. May fit other drone motors. Requires 16x19 screw arrangement on the back. Requires Arduino, Potentiometer, Drone motor, ESC, Two Switches, Wires, Soldering Tool. Wiring: Arduino to ESC ESC Signal Pin connected to Arduino Pin 9 (PWM output for motor control). ESC Ground Pin connected to Arduino GND. ESC Power Pin connected to a power supply (not directly from Arduino; use a separate battery or 5V supply suitable for the motor). Arduino to Potentiometer: Potentiometer Signal Pin connected to Arduino Pin A2 (analog input). Potentiometer Power Pin connected to Arduino 5V. Potentiometer Ground Pin connected to Arduino GND.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!