Venus box cap

Modification for https://www.thingiverse.com/thing:1559232 and credit to him for an awesome design.

Was asked for a cap so that buds wouldn't fall out of the box so I made this as part o my Fusion 360 self teaching process. Enjoy. Optimized for Ender 3 generic 0.4mm nozzle 0.2mm layers.

V1 - Prints fine alone but I'm on junk filament. Loose fit so you might want to up it by 0.5% on the scaling but the handle holds against/near enough the cap so it won't fall out when closed.

V2 - Having problems printing with translucent dollar store filament that's been in a gas heated room for a month and Cura's click n place tabs aren't helping well enough so here's a version with a bed adhesion helper in the center. No problems with the bridge helper in the middle now. Just peel off the thing. 10mm x 0.25mm adhesion tab

Highly recommend that you print with 100% fan over layer 5 especially when printing alone.