Thingiverse
Version2 Nitro starter adapter
door NitzscheModellbau
9
Downloads
4
Likes
0
Makes
The starter is a lot in use for RC cars so version one broke after a while and the shaft just spinned around so in version two I added two screws to tighten the shaft.
Needs 2pcs M3 nuts and 2pcs M3x12 hex screws.
If your shaft is bigger than the design allows just drill it out a little bit and tighten the screws and it should still clamp.
Needs 2pcs M3 nuts and 2pcs M3x12 hex screws.
If your shaft is bigger than the design allows just drill it out a little bit and tighten the screws and it should still clamp.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
