Thingiverse
VertexEvo Y-visor
door Bo_Ris
8
Downloads
6
Likes
0
Makes
This is remix of Y-visor for VertexEvo printer.
After adding print-bed side support and extending print area along Y-axis I discovered that the original visor hits the top piece of right support before print-head reaches new Y=0 position. So I completely redesigned the visor and publishing it here.
You will need three M3 self-locking nuts, one M3x25mm and one M3x16mm screws. Optionally, to add slightly more weight to the front side of the visor, you can use one more M3x16mm screw and M3 nut.
The images show how to put things together. Make sure that Y-visor_part3 moves freely and closes Y-stop sensor only when pushed towards the back of the printer by XY_clamp.
After adding print-bed side support and extending print area along Y-axis I discovered that the original visor hits the top piece of right support before print-head reaches new Y=0 position. So I completely redesigned the visor and publishing it here.
You will need three M3 self-locking nuts, one M3x25mm and one M3x16mm screws. Optionally, to add slightly more weight to the front side of the visor, you can use one more M3x16mm screw and M3 nut.
The images show how to put things together. Make sure that Y-visor_part3 moves freely and closes Y-stop sensor only when pushed towards the back of the printer by XY_clamp.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
