Thingiverse
Vertical Charging Stand - Pebble Time
by Das_ENGINER
27
Downloads
16
Likes
0
Makes
Fairly straight forward vertical stand for the Pebble Time, designed to allow the straps to hang downwards instead of requiring you to feed them through gaps as required in other designs.
The charging cable is secured into the printed part with a small strip of 3M 03609 VHB tape. The wire easily pushes into the groove, and is also held in place with a few strips of the same VHB. I strongly recommend you pick a place for the stand and affix it there with some Command Adhesive strips between the bottom of the stand and the surface top; the weight of the stand is not sufficient to allow you to just pull the watch off.
Printed on an UM2 with 0.2mm layer heights at 40 mm/s, 50% infill for structural rigidity. Support needed on the wire channel.
The charging cable is secured into the printed part with a small strip of 3M 03609 VHB tape. The wire easily pushes into the groove, and is also held in place with a few strips of the same VHB. I strongly recommend you pick a place for the stand and affix it there with some Command Adhesive strips between the bottom of the stand and the surface top; the weight of the stand is not sufficient to allow you to just pull the watch off.
Printed on an UM2 with 0.2mm layer heights at 40 mm/s, 50% infill for structural rigidity. Support needed on the wire channel.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
