MakerWorld
Other Fashion Models
Zum Modell
Vertical stand for basecap organizers
23
Downloads
14
Likes
3
Makes
Standing flat the cap organizers took too much space. This stand can hold two cap organizers vertically. The model itself contains two parts - the base stand and the top connector.The cap organizers themselves are not part of the model. My cap organizers wall thickness is 3mm. In case yours has a higher or lower wall thickness you can scale it up or down. Link to fit test part with reduced length:https://makerworld.com/de/models/2263818-fit-test-part-for-vertical-stand#profileId-2466953I printed it with Bambu PLA Basic and it works fine. No experience with other filaments. Will not work with just one cap organizer. Any feedback is welcome.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
