Vertical view tablet stand

My tablet cover only has two positions, both oblique. To look at the tablet lying down I keep it in the vertical position, and since the cover does not support this option, I constantly had to pick it up from frequent falls. So I modeled a very simple block for the vertical position, to put between the tablet and its cover. ---------------------------------------------------------------------- The thickness of the tablet slot is 8 mm, and it supports most devices.In particular, the tablet shown in the photos is a Samsung S6 Lite. To interfere as little as possible with the light coming from the screen:a) the layer height was lowered to 0.16 mm;b) I used a matte effect pla, in my case PLA-CF. To reduce plastic consumption to the bare minimum, the structure is limited to perimeters only. If you prefer it closed, change the parameters in the slicer. ---------------------------------------------------------------------- Print profile overview:1) Stand (100% X, 100% Y, 66.67% Z). The 100% s