Thingiverse
Vertical Wall Vent
von Simon--69
6
Downloads
2
Likes
0
Makes
Many thanks to NickWaterton
Needed a vertical vent to use on my shed as metal box panel only 70mm wide (which is length on print)
No skills in using Fusion360 but enough to rejig using OpenSCAD
Couldn't figure out how to off set the louvres as the top gap is bigger than the bottom gap (OCD perfection)
Removed text and magnets holder
Haven't printed yet but don't see any problems. Will update later
Needed a vertical vent to use on my shed as metal box panel only 70mm wide (which is length on print)
No skills in using Fusion360 but enough to rejig using OpenSCAD
Couldn't figure out how to off set the louvres as the top gap is bigger than the bottom gap (OCD perfection)
Removed text and magnets holder
Haven't printed yet but don't see any problems. Will update later
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!