Slicer Discord
Vesa bracket attachment arm 100mm – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Vesa bracket attachment arm 100mm

60 Downloads
43 Likes
9 Makes
Zum Modell
This is an arm extension to add a small 7 inch screen to the back of Vesa mount bracket on pc screen.Compatible for the 100mm holes. The bracket is compatible with the 7 inch LCD screen case too: https://makerworld.com/en/models/442662#profileId-348618 Hardware list:M3x15mm = 4 pieces (for tilt Hinge)M5x30 mm = 1 piece ( to connect the two hinges)M5 nut = 1 piece (to tighten the hinges)M4x20mm = 2 pieces (for the vesa bracket bolts to monitor's back) size may vary due to your screen bolt - check your OG bolt size and add 8mm to it will be the bolt you need to use instead of 20mm).Note: you might need to squeeze the bracket for the holes to alight, don't worry it wont break. Boost Mei would appreciate the support ^^ it will keep me motivated to post exclusively on makerworld.
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Fortgeschritten Niedrige Konfidenz
Warum?
4-teiliger Zusammenbau · aufwändige Nachbearbeitung
4 Teile zum Zusammenbau Hardware nötig
Supports 1/3
Zusammenbau 2/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Polycarbonate
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

TriDee Design veröffentlicht auch auf

59 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen