VESA mount holder

Mounting solution (holder) for Mini PC like "HP 260 G2", "HP 260 G3" and all other VESA-compatible devices

I needed a simple and inexpensive solution for attaching a mini PC to a display. But branded mounts from HP are expensive, so this solution was invented.

This mount is great for devices and monitors with a VESA 100*100mm mount.

The use of this mount is not limited to the display only. You can use it on other surfaces: wall, table, under the table(!). When attaching to wooden surfaces, the screw must be replaced with a wood screw for of suitable length (for holder-final-part3.stl)

Additionally, 4pcs M4**12mm and 4pcs M4**15mm flat head screws are required (In my case).
The length of the screws may vary in your case (depending on the monitor and device)

The part holder-final-part1.stl must be screwed on without special effort, so that the part after installation can be turned 90 degrees down. See photos.

One mounting kit required:

holder_final_part1.stl - 1pcs