Thingiverse
VEX Magplates
von CatIsLiquid
0
Downloads
0
Likes
0
Makes
Made for use with 3mmx10mmx60mm neodymium magnets
https://a.co/d/apkTCd7
Run a script to pause your print when the hole is finished and insert the magnet before resuming the print.
When inserting magnets, make sure to align your magnets before hand. I would recommend adding tape onto the "top" side of each magnet (stack them all onto each other so you know they are compatible after printing them) in order to make placement less confusing.
Blank plate for teams to put on team names and graphics.
Plate designs for $10, DM catisliquiddd on Discord.
https://a.co/d/apkTCd7
Run a script to pause your print when the hole is finished and insert the magnet before resuming the print.
When inserting magnets, make sure to align your magnets before hand. I would recommend adding tape onto the "top" side of each magnet (stack them all onto each other so you know they are compatible after printing them) in order to make placement less confusing.
Blank plate for teams to put on team names and graphics.
Plate designs for $10, DM catisliquiddd on Discord.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!