Thingiverse
Vexclaw Extender
by Victor2266
2
Downloads
4
Likes
0
Makes
This is an extension for the standard vexclaw, I just attached it to the vexclaw with 3 zipties and mirrored the model in Cura for the right side of the claw.
The holes for the zipties are a bit small and you might want to check if your zipties are too wide. Also the tip of the claw is a bit thin.
The holes for the zipties are a bit small and you might want to check if your zipties are too wide. Also the tip of the claw is a bit thin.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
