Thingiverse
Vibration Suppression Damper
by Masai001
8
Downloads
5
Likes
0
Makes
Updated, Bolts-2 difficult to break.
By attaching a damper to the lower ground plane of 3D printer you can halve printing noise and vibration. By placing tennis balls, soft baseballs, etc. on the damper and the floor surface, stabilizing the installation of the 3D printer and suppressing the noise generated around it. The figure below is after installation on the ALUNAR - M508, the noise can be reduced to about half.
DEMO:
https://www.youtube.com/watch?v=OPDsMhkbRDA
By attaching a damper to the lower ground plane of 3D printer you can halve printing noise and vibration. By placing tennis balls, soft baseballs, etc. on the damper and the floor surface, stabilizing the installation of the 3D printer and suppressing the noise generated around it. The figure below is after installation on the ALUNAR - M508, the noise can be reduced to about half.
DEMO:
https://www.youtube.com/watch?v=OPDsMhkbRDA
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
