Thingiverse
VIC bobbins/replication
di BrraaddK
0
Download
0
Likes
0
Makes
The parts here are used to make/replicate Stan Meyer's VIC using 10mm x 100mm MnZn Ferrite rods.
Use supports on brakets and bobbins. Thread a short 4-40 screw into bobbin flange holes and use ring terminals with wire soldered to the terminal for a good connection. With these bobbins and rods you can get a pretty close match to Stan's original VIC.
,BradK
Use supports on brakets and bobbins. Thread a short 4-40 screw into bobbin flange holes and use ring terminals with wire soldered to the terminal for a good connection. With these bobbins and rods you can get a pretty close match to Stan's original VIC.
,BradK
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!