Vigour WC Button Frame

A locking clip on the flush button's mounting frame broke off. At first, I couldn't find the frame as a replacement part, so I redesigned it. Unfortunately, I had problems with my filament. Either the support couldn't be completely removed, or the material wasn't stable enough, and the frame broke. Then, I found and bought a replacement, but the frame is only available complete with cover and button panel.
Maybe someone else needs the design after all.
It may be necessary to adjust the taper of the magnetic holes slightly.

When printed flat, it requires a lot of support. When printed at an angle, it doesn't need as much support material, but my PETG was apparently too moist, so the layers didn't hold well. Maybe it will work for you.

Be careful with the original magnets, they are so strong that they can break when they snap together.