Thingiverse
Vimin Network switch wall mount
door neo8223
0
Downloads
0
Likes
0
Makes
Using the server rack mount screw holes and the original screws, this REALLLY basic design works well.
I printed PETG at 30% infill, seemed to hold well. I did over tighten it when mounting to the wall, but the 2 screw holes per side was ample for the strength.
You can also use the original screws that come with the switch too.
I printed PETG at 30% infill, seemed to hold well. I did over tighten it when mounting to the wall, but the 2 screw holes per side was ample for the strength.
You can also use the original screws that come with the switch too.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!