Thingiverse
Vintage Pendant
by MaeLee
41
Downloads
49
Likes
0
Makes
I love creating jewelry. I especially like the Victorian and Vintage look.
I also like the look of wood jewelry so I used wood filament to make this pendant. (MG Chemicals Wood Filament) I painted the flowers and then brushed on some gold metallic acrylic paint to give it character and shine.
This is a large piece and took over an hour to print on my Monoprice Mini Select IIIP using a print speed of 2.0 mm. You can scale the print to whatever size that you prefer. I scaled the one in the picture to:
Size X (mm) 49.0
Size Y (mm) 66.441
Size Z (mm) 13.288
If you scale it to the above numbers that I listed the pendant will be approx,
1/34 inches wide
2 inches tall not counting the hook
You could also use this as an ornament if you prefer. Enjoy !
I also like the look of wood jewelry so I used wood filament to make this pendant. (MG Chemicals Wood Filament) I painted the flowers and then brushed on some gold metallic acrylic paint to give it character and shine.
This is a large piece and took over an hour to print on my Monoprice Mini Select IIIP using a print speed of 2.0 mm. You can scale the print to whatever size that you prefer. I scaled the one in the picture to:
Size X (mm) 49.0
Size Y (mm) 66.441
Size Z (mm) 13.288
If you scale it to the above numbers that I listed the pendant will be approx,
1/34 inches wide
2 inches tall not counting the hook
You could also use this as an ornament if you prefer. Enjoy !
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!