Thingiverse
Vinyl Cut PCB resist
von connors934
0
Downloads
2
Likes
0
Makes
This image can be cut on a vinyl cutter, then attached to a copper clad board before etching it.
The traces you get from this process are really well defined.
If you put the board in a jar, you can agitate it very well with much less hazard of splashing.
For more info, check this post out: http://blog.makezine.com/2009/10/02/vinyl-cut-pcb-resist/
The traces you get from this process are really well defined.
If you put the board in a jar, you can agitate it very well with much less hazard of splashing.
For more info, check this post out: http://blog.makezine.com/2009/10/02/vinyl-cut-pcb-resist/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!