Thingiverse
Viper Remote Cover
por MushiSushi
1
Descargas
3
Likes
0
Makes
Designed a cover for my Viper Remote Starter to prevent accidental button clicks.
I had to use supports on the inside (Supports Everywhere) in order to make sure the center doesn't collapse. Also, I blocked supports closes to the sides as I found it hard to remove the supports when it is too close to the edges. (This is all dependent on your printer).
I had to use supports on the inside (Supports Everywhere) in order to make sure the center doesn't collapse. Also, I blocked supports closes to the sides as I found it hard to remove the supports when it is too close to the edges. (This is all dependent on your printer).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
