Thingiverse
Virb 360 Camera Lens Cap
by splabble
1
Downloads
1
Likes
0
Makes
A simple snap on lens cover for the Virb 360 camera.
Printed well enough for me with 0.2mm layer height, 30% infill and the flat side on the print bed (as shown in the STL). No supports or rafts were needed.
Video of it in use: https://youtu.be/8yZYAsAmV_g
____
Also included is a single unconnected cap - it should have a fairly good push-fit grip with the lens housing, so two could be used as an alternative. It has a flat base so should be printable vertically without support material (not tested).
____
lens cap, lens protector, lens cover, virb, virb 360, camera, grip, camera accessories
Printed well enough for me with 0.2mm layer height, 30% infill and the flat side on the print bed (as shown in the STL). No supports or rafts were needed.
Video of it in use: https://youtu.be/8yZYAsAmV_g
____
Also included is a single unconnected cap - it should have a fairly good push-fit grip with the lens housing, so two could be used as an alternative. It has a flat base so should be printable vertically without support material (not tested).
____
lens cap, lens protector, lens cover, virb, virb 360, camera, grip, camera accessories
splabble also publishes on
7 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
