VKB toe brakes addon

Use arduino pro micro to control 2 analog axes with 49e hall effect sensors. You will need 4 626 type bearings, 2 axles with m6 thread, 2 magnets d5 8mm thickness. and some small screws to hold cover on top. Claps uses m3 bolts and nuts,
Print every part for one sde, then print for another mirrored clamp A, clamp B and pedal. Cover and middle clamp is symetrical. Use tosion springs in middle. Inner diameter of spring coil is 8mm
Use joystick library to controll axes.

I made one mistake, so pedals are wider by 1.5cm than axis, but ir works as intended