VM275T basic mount using rubber bands or screws

This is a simple mount for a VM275T FPV camera & transmitter all-in-one unit. It is designed to be easily transferable between RC models and to leave the camera as open as possible to help keep it cool. Rubber bands can be looped around the mount to fix it to a RC model. The camera itself is also held in place with a rubber band.

There are also 3 screw holes that can be used as an alternative to rubber bands. The pair of screws provided with cheap 9g servos are ideal for this. If the centre screw is fitted the head of the screw should be covered with a small piece of sticky tape to prevent it from making contact with the underside of the circuit boards.

After printing you will probably need to clean up the semi-circle shaped lens support with a small file or some sandpaper.

This mount may work with other FPV systems that fit between the 15mm side supports and have the lens offset to the left by about 1mm.

My advice is to always use 2 or more rubber bands in case any single